user manual

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-82clear pkt
8
Examples
clear mst
Description
This command is usually used before enabling the trace. It may be used while
the trace is enabled to clear unwanted data.
Defaults
None.
Parameters
None.
Help Messages
If HELP is pressed after entering "clear mst," the following message is displayed:
Entry is not required
Error Messages
If the command entered is in conflict with another currently executing command,
then a message is displayed showing the login id of the conflicting user and the
conflicting command. A conflict could occur if another user was executing an
enable, disable or clear message sequence trace command at the same time.
The message is as follows:
’login id’:’command’ has a command conflict
Output
After the user has entered the command the following message appears at the
bottom of the screen:
Command successfully completed
Feature Interactions
None.
clear pkt
This command forces a packet bus ’clear stimuli’ to be sent over the packet bus.