user manual

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-304release station
8
Output
For the following output example, assume that the standby SPE is located in
carrier "B." The command that was entered is "release spe-standby."
Feature Interactions
When the standby SPE is released a memory refresh is performed which may
take several minutes to complete. The standby Fault Severity Level will be
lowered to its appropriate level when a release is requested. One minute later,
the equivalent of scheduled standby SPE maintenance will be performed, after
which a spontaneous SPE interchange could occur, depending of the Fault
Severity Level of the two SPE’s.
If the standby SPE is in poor health, memory shadowing can not be enabled or
communication to the standby is impossible, a release of the standby SPE will
still be successful.
release station
This command will release a specified station.
Synopsis
release station extension
Port The port address will display the cabinet and carrier location of
the standby SPE. The standby SPE port address will always be
01A or 01B.
Maintenance Name "STBY-SPE" for the standby SPE maintenance object.
Alt. Name Always blank for this command.
Result The result of the release -"PASS," "ABORT," "FAIL,"
Error Code A system-generated number that tells why the release failed or
aborted. A detailed list of the codes can be in the
"Busyout/Release Commands" section of this chapter.
release spe-standby SPE A
COMMAND RESULTS
Port Maintenance Name Alt. Name Result Error Code
01B STBY-SPE PASS
Command successfully completed