user manual

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-329reset system
8
If the "health-override" option is specified with any level of 1 - 5, the following
message will be displayed:
The ’health-override’ option is only used
with the ’interchange’ level
If the command entered is in conflict with another currently executing command,
then a message will be displayed showing the login id of the conflicting user and
the conflicting command. The message is as follows:
’login id’:’command’ has a command conflict
If this command is issued while an upgrade software command is active the
following message will be displayed:
Standby SPE upgrade in progress, command denied
Output
If the reset command, including the "reset system interchange," is successful the
user will be logged off.
If the "reset system interchange" command is not successful one of the following
are displayed:
If the "interchange" option is specified and the active SPE is locked active, the
following message will be displayed:
Unable to interchange because the
active SPE is locked active
If the "interchange" option is specified and only the Fault Severity Level of the
standby SPE is preventing the interchange, the following message will be
displayed:
Unable to interchange due to alarms on the standby SPE;
Use ’health-override’ option
If the "interchange" option is specified and the standby SPE is busied out, the
following message will be displayed:
Unable to interchange; standby SPE is busied out
If the reset interchange command cannot be performed for any other reason, the
following message will be displayed on the SAT:
Cannot perform SPE interchange;
for information use ’status system’