user manual

ManualsBrandsLucent Technologies ManualsComputer HardwareComputer Hardware R5SI

781

782

783

784

785

786

787

788

789

790

DEFINITY Enterprise Communications Server Release 5

Maintenance and Test for R5vs/si

555-230-123

Issue 1

April 1997

Maintenance Commands and Trouble-Clearing Aids

Page 8-567test data-module

Extension not assigned

If the object associated with the specified extension is not a data module or a

data channel, the following message will be displayed:

Extension exists but assigned to a different object

If the EPN that contains the data module port is not accessible, the following

message will be displayed:

EPN is not available

If the board that contains the data port is not configured in the system, the

following message will be displayed:

Board not assigned

If no tests can be found for the current MO, the following message will be

displayed:

No tests for this MO

If the command entered is in conflict with another currently executing command,

then a message will be displayed showing the login id of the conflicting user and

the conflicting command. The message is as follows:

’login id’:’command’ has a command conflict

If during the execution of a command a resource problem occurs that requires

the user to restart the command, then the following message will be displayed:

Command resources busy;

Press CANCEL to clear, and then resubmit

If all of the available maintenance resources are currently in use, then the

following message will be displayed:

All maintenance resources busy; try again later

Output

The responses will be displayed on a test-by-test basis with one line of data

displayed for each test result.

Port The port address (cabinet-carrier-slot-circuit) of the maintenance

object that is being tested.

Maintenance Name The type of maintenance object that is being tested.

Alt. Name The alternate means of identifying the maintenance object. This

field contains the extension when the object is a station, and it

contains xxx/yyy when the object is a trunk, where xxx is the trunk

group number and yyy is the member number. It contains P/xxx

when the object is a private CO line, where xxx is the private CO

line group number.