user manual

DEFINITY Enterprise Communications Server Release 5
Maintenance and Test for R5vs/si
555-230-123
Issue 1
April 1997
Maintenance Commands and Trouble-Clearing Aids
Page 8-639test pms-link
8
Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message will be displayed:
All maintenance resources busy; try again later
Output
The responses will be displayed on a test-by-test basis with one line of data
displayed for each test result.
For the following example, the command entered was "test pms-link l".
Feature Interactions
The maintenance of a particular component on a link may interfere with the
maintenance of the link itself. Maintenance can put a link component in a busy
state causing link set-up to fail. Frequent attempts at re-setup of a link may delay
the recovery of a faulty component, due to the maintenance test of a component
only taking place when the component is idle. Therefore, the technician needs to
be able to disable the attempted re-setup of a link. The busyout command is
used to do this, and causes the link to be torn down. If the link is already down,
the busyout command stops periodic re-setup tries on the link.
Port With this object the port field is blank.
Maintenance Name The type of MO that is being tested (always PMS-LINK).
Alt. Name Not applicable.
Test No The actual test that is being executed.
Result The result of the individual test -"PASS," "ABORT," "FAIL," "NO
BOARD," "DISABLED," "EXTRA BD."
Error Code A system-generated number that tells why the release failed or
aborted. A detailed list of the codes according to "Test No." is
provided for each MO.
test pms-link long
TEST RESULTS
Port Maintenance Name Alt. Name Test No. Result Error Code
PMS-LINK 214 PASS
Command Successfully Completed