Host-Based Controller Modem AT Command Set User's Manual

Data Addendum Host-Based Controller Modem
June 15, 1998 AT Command Set
Test and Debug AT Commands (continued)
Version 1.0 Lucent Technologies Inc.
27
Table 7 - errorControl Active from 3.5.2/V.58
Value Description Implemented
0 Disable/none X
1 V.42 LAPM X
2 V.42 Alternative protocol (MNP™) X
3-7F Reserved (V.58)
80 MNP10™
81 ECP™ Enhanced Cellular Protocol
82 ETC
82-FF Reserved for mfgs
Table 8 - compressionActive from 3.2.2/V.58
Value Description Implemented
0 None X
1 V.42bis X
2-7F Reserved (V.58)
80 MNP5™ X
81-FF Reserved for mfgs
Table 9 - Additional callCleared codes (3.6.4/V.58)
Code Definition Implemented
1 No Previous call X
2 Call is still in progress X
3 Call Waiting signal detected
4 Delayed - see ETS 300 001 X
Table 10 - callCleared codes from 3.6.4/V.58-1994
callCleared: Indicates that the DCE has gone on hook and that the previously existing network connection has
been cleared. These values are hexadecimal, converted from decimal in V.58.
Value Description Notes Implemented
0 CauseUnidentified Call setup issues X
1-3 See Table 9 above X
A NMSinitiatedDialCall -- Network Management System
B NMSinitiatedLeasedLineRestoral
C NMSinitiatedRedial
D NMSinitiatedDialDisconnect
14 PowerLoss DCE
15 EquipmentFailure
16 FrontPanelDisconnectRequested
17 FrontPanelLeasedLineRestoral
18 AutomaticLeasedLineRestoral
19 InactivityTimerExpired X
1E cct116RestoralRequest DTE Interface
1F cct108isOffInhibitsDial
20 cct108turnedOff
28 NoNumberProvided Line Interface
29 BlacklistedNumber X