User's Manual

ManualsBrandsLucent Technologies ManualsHome Theater ServerLucent Technologies lucent 555-233-119

1091

DEFINITY ECS Release 8.2 Maintenance for R8.2csi

555-233-119 Issue 1

April 2000

Maintenance Objects

3-530DIOD-DS1 (DS1 DIOD Trunk)

Table 3-223. TEST #7 Conference Circuit Test

Error

Code

Te st

Result Description/ Recommendation

ABORT System resources required for this test are not available.

1. Retry the command at 1-minute intervals a maximum of 5 times.

1000 ABORT System resources required to run this test are not available. The port may

be in use on a valid call. Use the status station or status trunk command

to determine when the port is available for testing.

1004 ABORT The port has been seized by a user for a valid call. Use the status station

or status trunk command to determine when the port is available for

testing.

1. Retry the command at 1-minute intervals a maximum of 5 times.

1018 ABORT Test disabled via administration. This only applies to analog stations.

1. To enable test, set the Test field on the station administration screen

for the particular analog station being tested to ‘‘y.’’ Use the change

station extension command.

1020 ABORT The test did not run due to a previously existing error on the specific port

or a more general circuit pack error.

1. Examine Error Log for existing errors against this port or the circuit

pack and attempt to diagnose the previously existing error.

2000 ABORT Response to the test request was not received within the allowable time

period.

2100 ABORT System resources required for this test are not available.

1. Retry the command at 1-minute intervals a maximum of 5 times.

2053 ABORT At least one of the following errors is found on the DS1 circuit pack:

1281—Loss of signal

1793—Blue Alarm

2049—Red Alarm

2305—Yellow Alarm

1537—Hyperactivity

Look for the above error types in the Hardware Error Log and follow the

procedures given in the appropriate DS1-BD or UDS1-BD maintenance

documentation for the listed error types.

FAIL The NPE of the tested port did not conference the tones correctly. This will

cause noisy and unreliable connections.

1. Replace the circuit pack.

PASS The port can correctly conference multiple connections. User-reported

troubles on this port should be investigated by using other port tests and

by examining station, trunk, or external wiring.

Continued on next page