User's Manual

ManualsBrandsLucent Technologies ManualsHome Theater ServerLucent Technologies lucent 555-233-119

1651

DEFINITY ECS Release 8.2 Maintenance for R8.2csi

555-233-119 Issue 1

April 2000

Maintenance Objects

3-1097TIE-DS1 (DS1 Tie Trunk)

Conference Circuit Test (#7)

One or more NPEs reside on each circuit pack with a TDM Bus interface. The

NPE controls port connectivity and gain, and provides conferencing functions on

a per-port basis. The Conference Circuit Test verifies that the NPE channel for the

port being tested can correctly perform the conferencing function. The NPE is

instructed to listen to several different tones and conference the tones together.

The resulting signal is then measured by a Tone Detector port. If the level of the

tone is within a certain range, the test passes.

Table 3-487. TEST #7 Conference Circuit Test

Error

Code

Te st

Result Description/ Recommendation

ABORT System resources required for this test are not available.

1. Retry the command at 1-minute intervals a maximum of 5 times.

1000 ABORT System resources required to run this test were not available. The port may

be busy with a valid call. Use the display port PCSSpp command to

determine the trunk group/member number of the port. Use the status

trunk command to determine the service state of the port. If the service

state indicates that the port is in use, then the port is unavailable for certain

tests. You must wait until the port is idle before retesting.

1. If the port status is active but the port is not in use (no calls), check the

error log for error type 1025 (see the error log table for a description of

this error and required actions). The port may be locked up.

2. If the port status is idle, retry the command at 1-minute intervals for a

maximum of 5 times.

1002 ABORT The system could not allocate time slots for the test. The system may be

under heavy traffic conditions, or it may have time slots out of service due

to TDM-BUS errors. The status health command can be used to

determine if the system is experiencing heavy traffic. Refer to the

TDM-BUS (TDM bus) Maintenance Documentation to diagnose any active

TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy traffic

and the port status is idle, retry the command at 1-minute intervals for

a maximum of 5 times.

Continued on next page