User's Manual

ManualsBrandsLucent Technologies ManualsHome Theater ServerLucent Technologies lucent 555-233-119

1661

DEFINITY ECS Release 8.2 Maintenance for R8.2csi

555-233-119 Issue 1

April 2000

Maintenance Objects

3-1102TIE-DS1 (DS1 Tie Trunk)

This second part of this test

CANNOT

be run on a trunk if one of the following

cases is true:

1. The trunk direction is administered as an incoming only trunk.

2. The trunk is the 24th port on a DS1 Interface circuit pack which is

administered using 24th Common Channel Signaling.

3. The trunk has been seized by a normal trunk call.

4. The trunk is administered with maintenance test disabled.

5. The outgoing signal type of the trunk is either automatic or

immediate-start.

Table 3-489. TEST #136 DS1 Tie Trunk Seizure Test

Error

Code

Te s t

Result Description/ Recommendation

ABORT Internal System Error.

1000 ABORT System resources required to run this test were not available. The port may

be busy with a valid call. Use the display port PCSSpp command to

determine the trunk group/member number of the port. Use the status

trunk command to determine the service state of the port. If the service

state indicates that the port is in use, then the port is unavailable for certain

tests. You must wait until the port is idle before retesting.

1. If the port status is active but the port is not in use (no calls), check the

error log for error type 1025 (see the error log table for a description of

this error and required actions). The port may be locked up.

2. If the port status is idle, retry the command at 1-minute intervals for a

maximum of 5 times.

1004 ABORT Far end is seizing the trunk while the test is ongoing. A glare situation is

detected. Current test is designed to be aborted. Use the display port

PCSSpp command to determine the trunk group/member number of the

port. Use the status trunk command to determine the service state of the

port. If the service state indicates that the port is in use, then the port is

unavailable for certain tests. You must wait until the port is idle before

retesting.

1. If the port status is idle, retry the command at 1-minute intervals for a

maximum of 5 times.

Continued on next page