User's Manual

DEFINITY ECS Release 8.2 Maintenance for R8.2csi

555-233-119 Issue 1

April 2000

Maintenance Objects

3-61ANL-LINE (8-Port Analog Line), ANL-NE-L (8-Port Neon Analog Line)

Station Status and Translation Audits and

Updates Test (#36)

This test updates the analog port’s message lamp state (if it has one) and

translations (such as station type, dial type, network connection) with information

kept in the software. The software is updated with the switchhook state reported

by the port processor. When the ringer is in the off state, this test also turns off the

station’s ringer to prevent constant ringing caused by defective hardware.

0NO

BOARD

The test could not relate the internal ID to the port (no board). This could be

due to incorrect translations, no board is inserted, an incorrect board is

inserted, or an insane board is inserted.

1. Check to ensure that the board translations are correct. Use the list

config command, and resolve any problems that are found.

2. If the board was found to be correctly inserted in step 1, issue the

busyout board command.

3. Issue the reset board command.

4. Issue the release busy board command.

5. Issue the test board long command. This should re-establish the

linkage between the internal ID and the port. If this is not the case,

dispatch to check to ensure that there is a valid board inserted.

Table 3-25. TEST #35 Battery Feed Test — Continued

Error

Code

Te s t

Result Description/ Recommendation

Continued on next page