User's Manual

DEFINITY ECS Release 8.2 Maintenance for R8.2csi 555-233-119 Issue 1
April 2000
Maintenance Objects
3-340CARD-MEM (Memory Card)
3
Memory Card Format and Read Test (#696)
This test is a nondestructive test. The memory card must be formatted before an
application. The test reads the directory file from the memory card, and it verifies
the integrity of the directory file.
Table 3-148. TEST #695 Memory Card Insertion Test
Error
Code
Te st
Result Description/ Recommendation
2012
2106
2114
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
2013
2100
none
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL No memory card is inserted in the Processor circuit pack, or the inserted
memory card has a bad connection.
1. Insert a memory card into the slot at the Processor circuit pack.
2. If a memory card is already inserted, take the memory card out and
examine the connectors of the memory card and the Processor circuit
pack. Insert the memory card into the slot again.
3. When a memory card is pushed into the slot, make sure that the
memory card is inserted firmly into the slot.
4. Re-enter the test card-mem command. If the test still fails, replace the
memory card, and then repeat this step one more time.
5. If the test still fails after you replace the memory card, replace the
Processor circuit pack. Follow the Standard Repair Procedures for a
memory card.
PASS A memory card is inserted into the Processor circuit pack, and the system
can recognize its existence.
Continued on next page
Table 3-149. TEST #696 Memory Card Format and Read Test
Error
Code
Te st
Result Description/ Recommendation
2012
2106
2114
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
Continued on next page