User's Manual

Administering the Switch for CMS High Availability Systems

CentreVu

CMS R3V8 High Availability

Connectivity, Upgrade and Administration

Administering the Definity Switch 4-6

Setting Up the

Link on the CMS

Computer

The following information must be obtained to set up the CMS link:

• switch name

• switch model (release)

• is Vectoring enabled on the switch (if authorized)?

• is Expert Agent Selection (EAS) enabled on the switch (if

authorized)?

• does the Central Office have disconnect supervision?

• local and remote port

The local and remote port assignments must be symmetrical

between the switch and the CMS. For example, if the CMS local port

is 1 and the remote port is 10, the switch local port must be 10 and

the remote port must be 1.

• the hostname or IP address, and TCP port

Note:

In addition to the switch administration presented in this

chapter, you must also set up the switch link on the CMS

computer using the setup or swsetup options of the

cmssvc command. This procedure is documented in

CentreVu

CMS Software Installation and Setup (585-210-

941)

Administering the

Definity

Switch 4

Overview 4

This section contains the procedures required to establish a

communications link between the CMS computer and the switch.

Administering

the LAN

Connection

Use the procedures in this section to administer the LAN connection to

the switch. This section contains examples of the switch administration