Instruction Manual

Configuring the RIP Routing Protocol (Layer 3)
8-2 Cajun P550/P220 Switch Operation Guide
3. Click APPLY to save your changes, or CANCEL to restore previous settings.
Modifying RIP Interfaces
To modify the RIP interfaces:
1. In the RIP Configuration section of the Web Agent window, click Interfaces.
The RIP Interfaces dialog box opens.
2. Use Table8-2 to modify RIP interfaces:
Purge TTL Specify the global Time To Live (TTL) in seconds that the RIP
update persists. The default value is 120 seconds.
Triggered Updates Enable or disable route updates that were triggered by a
topology change in the network to be added to the routing
table. The default is Enable.
Update Pkt Delay Specify the value (in seconds) that represents the time delay
between successive RIP update packets to the neighbor, when
the update requires multiple packets. The default value is 0
seconds (no delay).
Table8-2. RIP Interface Parameters
Parameter Allows you to...
Select Select the RIP interface to be modified.
Interface Displays an interface from a list of interfaces that you
previously configured.
Network Address Displays an IP address to be associated with the displayed
interface.
Mode Specify the RIP State. Different states include:
• talk only (send RIP information to the network)
• listen only (receive RIP information from the network)
• talk/listen (both send and receive RIP information from
the network)
Send Version Specify the version of RIP you want to use to send packets
across your interface. Selections include:
• V1
• V2
• V1/V2
Table8-1. RIP Global Configuration Parameters (Continued)
Parameter Allows you to...