Instruction Manual

Configuring AppleTalk Routing (Layer 3)
10-6 Cajun P550/P220 Switch Operation Guide
Creating an AppleTalk Static Route
To create an AppleTalk static route:
1. In the AppleTalk Configuration section of the Web Agent window, click Static
Route. The AppleTalk Static Route dialog box opens.
2. Click CREATE to add a new static route. The Add AppleTalk Static Route dialog
box opens.
3. Use Table10-2 to configure your static route.
4. Click CREATE to add the static route, or CANCEL to restore previous settings.
Table10-2. AppleTalk Static Route Parameters
Parameter Definition
Network Range Start Enter the starting network number. The network number
specifies the range of AppleTalk network numbers for
extended networks. Each number in the range must be an
integer between 1 and 65279.
Note: Network Range Start must be less than or
equal to Network Range End.
Network Range End Enter the ending network number. The network number
specifies the range of AppleTalk network numbers for
extended networks. Each number in the range must be an
integer between 1 and 65279.
Network Number Enter the next hop network number. This number specifies
the network number of the next hop router for the
network range.
Node Enter the next hop node identification number. This
number must be between 1 and 253.
Type Select the type of static route.
Options include:
• High - The static route is not superseded by a route
update.
• Low - The static route can be superseded by a route
update.
Zone Enter an AppleTalk zone name assigned to this route. Zone
names may be up to 32 characters in length.