Instruction Manual

10Index
upstream interface is pruned, 7-40
upstream neighbor router address, 7-40
upstream sources, 7-40
DVMRP neighbor routers
DVMRP supported major/minor version
, 7-35
expiration period, 7-35
found on interface, 7-35
neighbor is SNMP manageable, 7-35
neighbor network address, 7-35
neighbor received probe from this router, 7-35
neighbor supports generation ID function, 7-35
neighbor supports MTRACE requests, 7-35
neighbor supports prune function, 7-35
viewing, 7-34
DVMRP parameters
maximum number of routes
, 7-19
DVMRP route table parameters
designated forwarder
, 7-37
downstream dependent router, 7-37
expiration period in sec, 7-36
reporting router, 7-36
reporting router interface, 7-36
route metric, 7-36
source network, 7-36
source network mask, 7-36
upstream router, 7-37
DVMRP routing statistical parameters
current number of routes
, 7-36
number of trigger routes, 7-36
number of valid routes, 7-36
DVMRP routing table
displaying
, 7-36
DVMRP routing table statistics
displaying
, 7-35
DVMRP supported major/minor version
DVMRP downstream dependent router
, 7-39
DVMRP neighbor routers, 7-35
DVMRP upstream interface
upstream prune information
, 7-41
DVMRP upstream prune information, 7-40
DVMRP upstream routers
found on interface
, 7-37
router cost to source network, 7-37
router network address, 7-37
viewing, 7-37
DVMRP upstream source parameters
destination group address
, 7-42
destination port number, 7-42
flow source address, 7-42
flow upstream interface, 7-42
payload protocol type, 7-42
source port number, 7-42
DVMRP upstream sources, 7-42
E
echo reply rx
AppleTalk global statistics
, 10-12
echo req rx
AppleTalk global statistics
, 10-12
echo req tx
AppleTalk global statistics
, 10-12
editing an AppleTalk static route, 10-7
editing an AppleTalk zone filter, 10-10
editing an NBP filter, 10-8
editing AppleTalk interfaces, 10-4
editing general system information, 3-33
egress rules
VLAN
, 12-2
enable
spanning tree bridge port information parameters
,
12-10
enable state
CGMP snooping parameters
, 15-18
enable state, 15-5
IGMP snooping, 15-12
LGMP client configuration parameters, 15-16
LGMP server configuration parameters, 15-13
enabling
enabling IRDP
, 7-46
enabling AppleTalk global routing, 10-2
enabling controller redundancy, 3-42
enabling fast start mode for all ports on a module, 3-22
enabling fast start mode for individual ports, 3-22
enabling gigabit ports, 3-7, 3-9
enabling SNTP, 3-34
enabling the rate limit mode
Fast Ethernet module
, 3-10
enabling VRRP, 7-43
encapsulation type
AppleTalk interface parameters
, 10-3
end
one-time summer time hours configuration
, 3-37
summer time hours configuration, 3-35
end network
IPX RIP filter parameters
, 5-3
entries removed due to route changes
forwarding cache (FE) parameters
, 11-6
entries removed due to route deletes
forwarding cache (FE) parameters
, 11-6
entry expiration period in sec
IGMP group membership table parameters
, 7-31
entry type
address table instance parameters
, 14-2
entry validity
address table instance parameters
, 14-3