Owner's manual

Configuring the OSPF Routing Protocol (Layer 3)
9
-
4 Cajun P550/P220 Switch Operation Guide
2.
Select the
OSPF area
to be removed.
3.
Click
DELETE
. The OSPF area is removed.
Modifying OSPF Areas
To modify an OSPF area:
1.
In the
OSFP Configuration
section of the Web Agent window, click
Areas
. The
OSPF Areas dialog box opens.
2.
Select the
OSPF area
to be modified.
3.
Use Table 9-2 to modify your configuration.
4.
Click
APPLY
to save your changes, or
CANCEL
to restore previous settings.
Modifying OSPF Interfaces
To modify an OSPF interface:
1.
In the
OSPF Configuration
section of the Web Agent window, click
Interfaces
.
The OSPF Interfaces dialog box opens.
Note:
If OSPF is not enabled for your existing IP interfaces (VLANs) you must first
enable OSPF before you can modify OSPF interfaces. Refer to “Configuring
IP Interfaces” in Chapter 7 for more information on how to enable OSPF on
IP interfaces.
2.
Use Table 9-3 to determine how to modify your OSPF interfaces:
Table 9-3. OSPF Interface Parameters
Parameter Definition
Select Select the OSPF interface to be modified.
Interface Displays IP interface (VLAN) that has OSPF enabled.
Note:
This is a read-only field.
IP Address Displays IP address associated with the OSPF interface.
Note:
This is a read-only field.
Area Enter the area ID configured for this interface.
DR Priority Enter the decimal value for this interface for DR priority
functionality.
Tra n s it D elay Enter the estimated number of seconds it takes to transmit a link
state update packet over this interface.