User manual

MERLIN LEGEND Communications System Release 6.0

System Programming

555-660-111

Issue 1

February 1998

Common Administrative Procedures

Page 4-363Automatic Route Selection

Automatic Route Selection 4

This section contains programming procedures for the following Automatic Route

Selection (ARS) features:

■ 1 + 7-Digit Dialing Requirements

■ ARS Tables

■ Start and Stop Times for Subpatterns

■ Pool Routing

■ Facility Restriction Level (FRL)

■ Digit Absorption

■ Other Digits

■ N11 Special Numbers Tables

■ Dial 0 Table

■ Voice and/or Data Routing

NOTE:NOTE:NOTE:

ARS applies to Hybrid/PBX mode only.

ARS over Networked Tandem PRI

and Tie Trunks 4

In Release 6.0 and later systems, Hybrid/PBX mode only, callers on one system

can use lines on another system speedily and transparently when optimal cost

efficiency dictates the need for lines connected to a different switch in the

organization’s private network (in prior systems, it is necessary to make an explicit

remote-access call, enter a barrier code, and finally use ARS). To permit this

operation, both the local and remote systems must be programmed using ARS

and remote access options.

Remote Users Calling out on Local

Networked Lines 4

To implement this operation on a local system where remote callers will use the

networked lines connected to your system, use the procedures outlined in the

section “Remote Access Features” on page –337