Use And Care Manual

Lucid Audio Amped Bluetooth® Headphones
(HLT-BT-H-PH Series)
These Amped Bluetooth® Headphones were engineered from the ground up with the goal of having the lowest
possible profile without compromising the hearing protection, amplification, and wireless sound properties of
the headphones. Delivering an impressive NRR of 21dB, the Amped Series Bluetooth® Headphones by Lucid
Audio are sure to enhance and protect your hearing, while allowing you to listen to music or take phone calls.
Power On:
-Short press the Bluetooth® Sync button to turn on the Bluetooth® feature (LED will flash every 1 second).
Power Off:
-Long press and hold the BT button for 3 seconds to turn off Bluetooth® device.
Pairing:
-Long press and hold the BT button for 1 second to enter pairing
mode after turn on (this will time out after 60-seconds).
-Open Bluetooth® wireless setting on your phone or mp3 player
-Make sure Bluetooth® is on and select “Lucid BT” to connect.
-Auto re-connect to previous last connected device during
pairing if the BT device has been paired previously.
-Once paired, blue LED will be flashing every 10 seconds.
Answer Call:
-Short press the BT button to answer incoming call.
Reject Call:
-Long press the BT button to reject the call.
Cancel/end call:
-Short press the BT button to cancel/end call.
Call on hold/waiting:
-During phone calls, if another new call is received, double
press the BT button to switch from the first call to second call.
-To switch back to first call, short press the BT button, which ends
the second call and it will be switched to previous call.
Last number redial:
-Double press the BT button to re-dial the last phone number.
Audio pause/play:
-Short press the BT button to pause/play music.
(TOLL-FREE CUSTOMER SUPPORT 800-775-7124)
www.lucidaudio.com
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. any use of such marks by Hearing Lab Technology, LLC is under license. Other
trademarks and trade names are those of their respective owner.
Volume
Control Knob
Bluetooth®
Volume Knob
Battery Compartment
Blueetooth Sync Button
Proper Fit:
-Place the headset over the head and secure the muff cups over each ear. Adjust the headband to ensure a secure fit.
CAUTION
- Do not mix old and new batteries.
- Do not mix Alkaline, Standard or Rechargeable batteries.
- Improper fit of this device will reduce its effectiveness in attenuating noise. Consult the enclosed instructions for proper fit.
NRR INFORMATION
Although hearing protectors can be recommended for protection against the harmful effects of impulsive noise, the Noise
Reduction Rating (NRR) is based on the attenuation of continous noise and may not be an accurate indicator of the
protection attainable against impulsive noise such as gunfire.
The level of noise entering a person's ear, when hearing protector is worn as directed, is closely approximated by the
difference between the A-weighted environmental noise level and the C-weighted environmental noise level.