Installation Guide

6 | Product Information
4
12" (30cm)
Start the second row with the
leftover cut part of the last
plank of the previous row. This
small plank should measure at
least 12” (30cm). Otherwise,
cut a new plank in half and
use it to begin the second row.
Whenever practical, use the
piece cut from the preceding
row to start the next row.
Roll the SPC
plank against the
previous row and
push it downwards.
11" (3 0cm)
6
8 9
5
Make sure that end
joints of all planks
should be staggered
30cm at least or more.
Click the short side
and place it tight to the
short end of the left
plank.
Drop the long side of the
plank into the previous
row and place it tight to
the previous plank with
an angle of 30 degrees,
and gently tap on the
end with a rubber mallet
so it firmly locks into the
previous plank until both
are at the same height.
Make sure both planks
are perfectly aligned.
After the first 2-3 rows of
planks are installed, they
should be checked with
a string line to ensure
that rows are still running
straight. If they are not,
it could be that the
starting wall has some
irregularities that caused
bowing in the installation.
7