Instructions

EN
18 | LUCTRA
English
TABLE CLAMP
You can screw or fasten your lamp to the wall or on tables with a thickness of up to 78 mm with
the TABLE CLAMP.
Wall mounting
▶see image3
NOTICE!
Risk of property damage!
Make sure that you check the type of wall and the load-bearing capacity of the wall
structure before the assembly. The enclosed rawlplugs are suitable for fastening the
TABLE CLAMP to concrete walls or solid masonry. You must use special rawlplugs
or install another support structure suitable for the load with different types of walls
(plasterboard, breeze block, etc.) and a deviating load-bearing capacity. Consult a
specialist if you are unaware of the subsurface.
1. Mark the four drill holes with the distances
x = 45mm
y = 50mm
DANGER!
Risk of fatal injury caused by drilling through supply lines!
Check for supply lines (e. g. power cables, gas and water pipes) before drilling into
the wall.
2. Drill the holes with a diameter of6mm and 60mm deep.
3. Fasten the TABLE CLAMP(5) to the wall with the enclosed screws ø4.5×50mm and wall
plugs.
4. Place the lamp onto the pin of the TABLE CLAMP(5).
Table-top mounting
▶see image4
1. Attach the adhesive foam pads(6) as shown.
2. Choose the orientation of the lower plate(7) depending on the thickness of the table and
tighten the clamping screw(9).
Note:
You can screw the clamping screws into three different holes. This allows you to over-
come obstacles, such as edge trims.
3. Fasten the lower plate(7) with the screws(8).
4. Fasten the TABLE CLAMP(5) to the table using the clamping screw(9). Tighten the clamp-
ing screw(9) with the enclosed Allen key.
5. Place the lamp onto the pin of the TABLE CLAMP(5).
6. Run the power cable through the designated opening(10).