User's Manual

6
If S/W is not installed, proper operation may not occur even device is successfully installed.
Please refer to “Software Installation” section of installation guide and install driver software.
< How to confirm whether pen is active >
• Upon inserting batteries, press pen tip or pen button in order to activate.
• The pen is properly activated, small beep sound created from ultrasonic wave will occur in very close distance to ear.
(Some may be insensitive to the sound since beep is significantly small)
• When the pen does not operate properly, or pen cursor jitters terribly.
- Please check whether dirt or stain is on pen battery or not. If it is so, remove it completely and operate again.
- Insert new battery in case of discharge or inferiority
(Discharged or inferior battery might be contained white power or deformed bulgy).
< Auto Power-off (Sleep) mode >
• When pen does not click within 30 seconds after last click, pen will be automatically initiated economical power-off mode.
< Pen tip and Pen button functions >
• Pen tip operates same as left button of mouse.
• Lower pen button operates same as left button of mouse/upper pen button operates same as right button of mouse.
• Change the Mint Control to Table Mode if you are using the product on a flat surface.
(It can be used on normal flat surface. You can change the tip to ball pen to write on the paper.)