Instructions / Assembly

INSTRUCTIONS

Preparing the water filter cartridge

Soak the filter cartridge upright in cold water for 10 minutes.

Rinse the filter cartridge under running water for 10 seconds and insert the cartridge

gently into the funnel opening of the water filter pitcher.

Fitting into the filter into the inner vessel

Place the inner vessel back into the filter pitcher ensuring the tallest part is facing towards

the front.

Fit the filter cartridge into the inner vessel, pressing it down to ensure a tight seal.

Put the lid back onto the pitcher

Fill the inner vessel with cold water and let water pass through the filter. Discard the water

and repeat the process once more.

Fill the inner vessel for a third time; your filter pitcher is now ready for use

For best results

To prevent the filter from drying out, keep the water level high enough so the bottom of the

filter is immersed at all times. If the filter has not been in contact with water for more than

48 hours re-soak it for 10 minutes and then reinstall it.

Store the filter pitcher in the refrigerator or a cool location, out of direct sunlight and away

from heat sources.

In the event of the filtered water not being used for more than 48 hours, we recommend

that the water is discarded and the filter pitcher re-fill with fresh water.

PAGE 1
INSTRUCTIONS Preparing the water filter cartridge Soak the filter cartridge upright in cold water for 10 minutes. Rinse the filter cartridge under running water for 10 seconds and insert the cartridge gently into the funnel opening of the water filter pitcher. Fitting into the filter into the inner vessel Place the inner vessel back into the filter pitcher ensuring the tallest part is facing towards the front. Fit the filter cartridge into the inner vessel, pressing it down to ensure a tight seal.