Installation Guide

ManualsBrandsLulani ManualsBathAruba Collection. Single Hole Single-Handle Bathroom Faucet. in Rose Gold finish

Table Of Contents

Installation Instructions

BA-410-01

Single Handle Bathroom Faucet

Thank you for selecting Lulani.

To ensure that your installation proceeds smoothly, please read

these instructions carefully before you begin.

Aruba

1. Faucet

2. Above sink hardware: rubber O-ring

3. Below sink hardware: rubber washer,

metal washer, screws, lock nut

4. Water supply lines

5. Escutcheon (4” Baseplate)

6. Over-ﬂow pop-up drain

Parts Included

Recommended Tools (not included)

1. Adjustable Wrench

2. Phillips Screwdriver

3. Safety Goggles

4. Flashlight

5. Bucket

6. Measuring Tape

7. Plumber’s Putty

8. Channel Locks

9. Allen Key

Fa u c e t C o

Note: This faucet

has been packaged

with an over-ﬂow

pop-up drain. DO NOT

use with a non-over-ﬂow

sink.

Summary of content (4 pages)

PAGE 1
Fa u c e t C o Installation Instructions Aruba BA-410-01 Single Handle Bathroom Faucet Thank you for selecting Lulani. To ensure that your installation proceeds smoothly, please read these instructions carefully before you begin. Parts Included 1. Faucet 2. Above sink hardware: rubber O-ring 3. Below sink hardware: rubber washer, metal washer, screws, lock nut 4. Water supply lines 5. Escutcheon (4” Baseplate) 6.
PAGE 2
Caution: Tips for removal of old faucet Always turn off the water supply before removing the existing faucet or replacing any part of the faucet. Open the faucet handle to relieve water pressure and ensure that water is completely shut off. Maintenance Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the ﬁnish and void your warranty.
PAGE 3
Step 3 Connect the water supply lines to the water valves. Tighten each end with an adjustable wrench. Do not over tighten! Check all connections (shown with arrows in the image) for leaks. Re-tighten if necessary. Step 4 2 From the top of the drain hole, place the rubber gasket (2) on to the drain (1). Then insert through the installation hole. From under the drain hole, the rubber gasket (3), plastic washer (4), and metal nut (5) will be installed. Install the non-threaded side in to the wall plumbing.
PAGE 4
Step 5 After installation is complete, remove the aerator to ﬂush for any possible debris. Turn the faucet handle all the way on, turn on the hot and cold water supply and ﬂush water lines for one minute. Re-install the aerator once complete. About our products Turn any bathroom into a luxurious, beach-front retreat with the Aruba Single Handle Bathroom Faucet.