Installation Guide

ManualsBrandsLulani ManualsKitchenCebu Collection. Swivel kitchen faucet. Brushed Stainless finish

Table Of Contents

Recommended Tools (not included)

1. Adjustable Wrench

2. Phillips Screwdriver

3. Safety Goggles

4. Flashlight

5. Bucket

6. Measuring Tape

7. Plumber’s Putty

8. Channel Locks

9. Allen Key

1. Faucet

2. Above sink hardware: rubber O-ring

3. Below sink hardware: rubber

washer, metal washer, mounting nut

4. Escutcheon (8” Baseplate)

5. Water supply lines

6. (optional) Stability collar

Parts Included

Installation Instructions

KA-300-30

Single Handle Kitchen Faucet

Thank you for selecting Lulani.

To ensure that your installation proceeds smoothly, please read

these instructions carefully before you begin.

Cebu

*Optional: Try out our Stability

Collar for additional security

which may be necessary for

thinner sinks, like those made

with Stainless Steel. Install under

the sink, between the rubber

washer and metal washer.

Fa u c e t C o

Summary of content (4 pages)

PAGE 1
Fa u c e t C o Installation Instructions Cebu KA-300-30 Single Handle Kitchen Faucet Thank you for selecting Lulani. To ensure that your installation proceeds smoothly, please read these instructions carefully before you begin. Parts Included 1. Faucet 2. Above sink hardware: rubber O-ring 3. Below sink hardware: rubber washer, metal washer, mounting nut 4. Escutcheon (8” Baseplate) 5. Water supply lines 6.
PAGE 2
Caution: Tips for removal of old faucet Always turn off the water supply before removing the existing faucet or replacing any part of the faucet. Open the faucet handle to relieve water pressure and ensure that water is completely shut off. Maintenance Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the ﬁnish and void your warranty.
PAGE 3
Step 3 A. For 1-hole installation, insert the faucet through the hole on the sink. B. For 3-hole installation, insert the faucet in to the base plate and then through the hole on the sink. *Note: Make sure that the rubber o-ring stays above the mounting surface for 1-hole installation or between the faucet and base plate for 3-hole installation.
PAGE 4
Step 5 Connect the water supply lines to the hot and cold water valves. Tighten with an adjustable wrench. Do not over tighten. HOT HOT COLD COLD Step 6 1 Remove the aerator with an aerator wrench (a quarter or ﬂat surface tool could also work). Turn the faucet handle all the way on, turn on the hot and cold water supply and ﬂush water lines for one minute. Reinstall the aerator with an aerator wrench. Check all connections on the faucet and pipes for leaks. Re-tighten if necessary.