Installation Guide

ManualsBrandsLulani ManualsKitchenKauai 1-Handle Pull Down Sprayer Kitchen Faucet in Matte Black

Table Of Contents

1. Adjustable Wrench

2. Phillips Screwdriver

3. Safety Goggles

4. Flashlight

5. Bucket

6. Measuring Tape

7. Plumber’s Putty

8. Channel Locks

9. Allen Key

1. Faucet

2. Spray head

3. Above sink hardware: rubber O-ring

4. Below sink hardware: rubber

washer, metal washer, mounting nut

5. Counterweight

6. Escutcheon (8” Baseplate)

7. Water supply lines

Installation Instructions

KA-320-30

Single Handle Pull- Down Kitchen Faucet

Thank you for selecting Lulani.

To ensure that your installation proceeds smoothly, please read

these instructions carefully before you begin.

Parts Included

Recommended Tools (not included)

Kauai

Fa u c e t C o

Summary of content (5 pages)

PAGE 1
Fa u c e t C o Installation Instructions Kauai KA-320-30 Single Handle Pull- Down Kitchen Faucet Thank you for selecting Lulani. To ensure that your installation proceeds smoothly, please read these instructions carefully before you begin. Parts Included 1. Faucet 2. Spray head 3. Above sink hardware: rubber O-ring 4. Below sink hardware: rubber washer, metal washer, mounting nut 5. Counterweight 6. Escutcheon (8” Baseplate) 7. Water supply lines 3 4 5 6 2 1 7 Recommended Tools (not included) 1.
PAGE 2
Caution: Tips for removal of old faucet Always turn off the water supply before removing the existing faucet or replacing any part of the faucet. Open the faucet handle to relieve water pressure and ensure that water is completely shut off. Maintenance Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the ﬁnish and void your warranty.
PAGE 3
Step 3 A. For 1-hole installation, insert the faucet through the hole on the sink. B. For 3-hole installation, insert the faucet in to the base plate and then through the hole on the sink. *Note: Make sure that the rubber o-ring stays above the mounting surface for 1-hole installation or *rubber between the faucet and base plate for 3-hole installation.
PAGE 4
Step 5 Connect the water supply lines to the hot and cold water valves. Tighten with an adjustable wrench. Do not over tighten. Then, Install the spray hose to the outlet hose. The outlet will connect with a simple push. Attention: Make sure that the inlet hoses are not twisted. hot supply hose cold supply hose push Step 6 The faucet should be ﬂushed for possible debris prior to using. Remove the nozzle head by hand twisting off.
PAGE 5
Step 7 Test the spray head while the water is running. Make sure that the nozzle head correctly changes between stream and spray mode properly. stop spray mode stream mode Then turn off the faucet and check that the nozzle head is functioning properly by pulling out or down. Step 8 Attach the weight to the middle of the spray hose. Turn the water valves back on and then turn on the faucet. Run the water ﬂow for 15 seconds to clean up the lines and check for any leaks.