Owner's manual

Section 5 - Attachments

5-4 31200608

5.5 USE OF THE CAPACITY CHART

To properly use the capacity chart (see page 5-5), the operator must first determine

and/or have the following:

1. An approved attachment. See “Approved Attachments” on page 5-1.

2. The proper Capacity Chart(s).

3. Weight of the load being lifted.

4. Load placement information:

a. HEIGHT where the load is to be placed.

b. DISTANCE from the front tires of the telehandler where the load is to be

placed.

5. On the Capacity Chart, find the line for the height and follow it over to the

distance.

6. The number in the load zone where the two cross is the maximum capacity for

this lift. If the two cross at a division between zones, the smaller number must

be used.

The number in the load zone must be equal to or greater than the weight of the load

to be lifted. Determine the limits of the load zone on the capacity chart and keep

within these limits.

Capacity Indicator Locations

OV0310

FT FT

150

cmcm

160170

180

190

200

-10

BOOM

EXTENSION

INDICATOR

BOOM ANGLE

INDICATOR

ATTACHMENT

IDENTIFICATION

PLATE

FORK

WEIGHT

STAMP

TRANSFER CARRIAGE

EXTENSION INDICATORS