Service Manual User guide
Table Of Contents
- 10709790_B_644B,6K,844C,8K,1044C,10K_Lull_Service_Mnl
- Quick Reference
- Revision Record
- Table Of Contents
- List Of Figures
- List Of Tables
- Section 1 Safety
- Section 2 Identification & Specifications
- Section 3 General Maintenance
- Section 4 Reference Diagrams
- Section 5 Supply, Pressure & Return Hydraulics
- Section 6 Boom & Transfer
- Section 7 Frame Tilt & Oscillation
- Section 8 Transmission
- Section 9 Brakes
- Section 10 Outriggers
Brakes
9-32
Service Manual — Models 644B, 6K, 844C, 8K, 1044C, 10K
Installation, Park Brake Pressure Switch
Models with Control Manifold Hydraulics
(Ref. Fig. 9-17) The following procedure describes installation of the park
brake pressure switch used on models with control manifold hydraulics.
1. Install a new brake pressure switch (Item 2) on reducer bushing
(Item 3). Tighten two or three turns past finger tight.
2. Reconnect wiring harness connectors (Item 1) to the connectors on
the brake pressure switch.
Models with Mid-Inlet Hydraulics
(Ref. Fig. 9-18) The following procedure describes installation of the park
brake pressure switch used on models with control manifold hydraulics.
1. Install a new brake pressure switch (Item 1) on the park brake. Tighten
two or three turns past finger tight.
2. Reconnect wiring harness connectors (Item 2) to the connectors on
the brake pressure switch. 3