User's Manual

When the battery on the remote is low, both buttons on the remote will ash
red. If one button on the remote ashes red but will not activate when you
press it, it’s out of battery.
Please recharge the remote. The remote uses the same charging cable as the
helmet. Just plug it into any USB plug to charge. Please note there’s a correct
orientation to plug in the charger to helmet and remote port. To get to the
charging port of your remote, take o your remote from the mount byt twist-
ing it anti clockwise. The charging port can be found underneath the remote.
If charged correctly, the remote and helmet button will light up Red when
charging and Green when fully charged.
If the helmet is not responding to the remote or you have purchased a new remote (one
helmet can pair with up to 2 remotes), please pair the remote and helmet. To pair the
remote to the helmet, follow these steps:
1) Ensure your helmet is turned o. Then press and hold the power button until the
lights turn on and look like they’re ‘breathing’ (fading in and out) rather than the usual
ashing (on and o).
2) Press and hold both buttons on the remote till you see both button lights turn on in
the same ‘breathing’ fashion.
3) Ensure your remote and helmet are next to each other. Press one button on the
remote.
4) Your helmet shouldrespond accordingly, and will automatically exit pairing mode. Your
helmet and remote are now paired.
5) If the helmet does not respond accordingly, re-try from step 1 and press the other
button on step 3.
PAIRING THE HELMET WITH THE REMOTE
EN
CONNECTING THE HELMET WITH YOUR PHONE
Connect your Lumos Helmet to your phone via Bluetooth by following these
steps:
1) Download the Lumos Helmet app.
2) Turn on Bluetooth on your phone and launch the app.
3) Follow the instructions on the app to pair the helmet with your phone.
USING THE AUTOMATIC WARNING LIGHTS
RESETTING YOUR HELMET
Using a motion sensor in the remote, Lumos Helmet senses when you’re
making a sudden change in motion and turns all the lights at the back of
your helmet solid red to indicate that you are slowing down. This feature is
still being rened, and is currently only available in beta. To activate and use
the automatic warning light feature, follow the instructions in the included
sheet titled “A NOTE ABOUT THE AUTOMATIC WARNING LIGHT FEATURE.”
Note: Activating the automatic warning light feature will also decrease the
battery life of your helmet and remote signicantly from a single charge.
2) Tighten or loosen the rear adjustment
dial to fit the circumference of your head as
required.
1) The helmet must fit properly to be effective. With a proper fit, the helmet
will not move back and forth or side to side while fastened. The helmet can
only protect if it fits well.
In rare situations you might nd your helmet gets “stuck” (eg. helmet cannot
be turned o or is non-responsive to button presses. In this situation your
helmet might need to be reset. To reset, simply connect your helmet to the
charger, and it will automatically reset itself. If you still encounter problems,
email us at [e-mail] and we will behappy to assist you!
FITTING INSTRUCTIONS