DSC250 SCALE for LF1050 and LF1090 Lifts USER MANUAL Read these instructions before using the Lumex Lift Scale. Save these instructions for future reference. The most current version of these instructions can be found online at www.grahamfield.com.
CONTENTS INTRODUCTION....................................................................................3 SAFETY..........................................................................................3 ASSEMBLY.INSTRUCTIONS................................................................5 COMPONENTS...............................................................................5 INSTALLATION.ON.LUMEX.LF1050.PATIENT.LIFT...................... 7 INSTALLATION.ON.LUMEX.LF1090.PATIENT.LIFT......................
INTRODUCTION Safety WARNING: Important! Read and understand these instructions before assembling or using the Lumex Lift Scale. If you do not understand any part of these warnings or instructions, contact a healthcare professional for direction in the use of this product. If the Lift Scale is not properly assembled, personal injury and damage to the Lift Scale could result. WARNING: DO NOT use this product without proper instruction from a healthcare professional.
WARNING: This product has a maximum weight capacity of 600 lb (300 kg). If patient weight exceeds maximum weight capacity, the scale will designate overload by displaying “-oL-”. DO not exceed the maximum weight capacity of the lift being used for measurement. WARNING: California Proposition 65 WARNING: This product contains a chemical known to the State of California to cause cancer and reproductive or developmental harm. WARNING: GF Health Products, Inc.
ASSEMBLY INSTRUCTIONS Components Ensure all components shown below are included in the package.
1. Follow these instructions to attach the scale to the LF1050 or LF1090 Lift using the included mounting hardware. Do not use any other mounting hardware than that provided. 2. Keep the scale in a cool, dry place. If operation temperature is over 104°F (40°C), the tolerance will not be accurate within 0.2 lb (0.1 kg). The storage temperature is 32°F ~158°F C (0°C ~ 70°). 3. When the low battery indicator ( ) appears in the lower right corner of the display, replace the battery (see MAINTENANCE section). 4.
Installation on Lumex LF1050 Patient Lift Install on Lumex LF1050 Patient Lift as shown above. Item numbers shown are those listed in the table shown on page 5. WARNING: Ensure scale is securely mounted as shown above before proceeding.
Installation on Lumex LF1090 Patient Lift Install on Lumex LF1090 Patient Lift as shown above. Item numbers shown are those listed in the table shown on page 5. WARNING: Ensure scale is securely mounted as shown above before proceeding.
OPERATION INSTRUCTIONS Keyboard Illustration Display Illustration Instructions for Use 1. Place sling to be used onto spreader bar without patient/resident/user. 2. Press the On/Zero button on the scale faceplate to zero-out the weight of the sling (this weight will remain zeroed out until the Off button is pressed). 3. Press the Kg/lb button to select mode you prefer.
4. Carefully lift the patient/resident/user in the sling and perform the lift so that all of the weight is supported by the lift. Stabilize the movement of the sling after lifting. 5. Weight will display on the scale. Press the Operate/Hold button to hold the weight displayed. To reset the scale to zero, press the Operate/Hold button again. 6. Lower patient/resident/user safely. 7. If you are weighing another individual using the same sling, perform the lift and their weight will display.
MAINTENANCE Cleaning As needed, wipe scale gently, using mild soap or a mild disinfectant. s NOTICE: DO NOT wash under water pressure or steam clean. DO NOT use solvents, abrasive cleaners, or scouring pads to clean scale. Battery Replacement When the low battery indicator ( ) appears in the display’s right corner, replace the battery: 1. Open the scale back battery compartment. 2. Remove battery and replace with a 9V alkaline battery. Ensure that battery polarity is correct. 3.
SPECIFICATIONS Model Number DSC250 Capacity 600 lb (300 kg) Resolution 1/3,000 ±1d Division 0.2 lb (0.1 kg) Power Source 9V alkaline battery x 1 Temperature Operating 32°F ~ 104°F (0°C ~ 40°C) Storage 32°F ~ 158°F (0°C ~ 70°C) Dimensions (W x H x D) 3.54 x 2.83 x 2.17 in. (90 x 72 x 55 mm) Product Weight 24 oz ± .35 oz / 1.5 lb ± .02 lb (675 g ±10 g) LCD Display 2.60 x 1.28 in. (66.0 x 32.
LIMITED WARRANTY GF Health Products, Inc. (“Graham-Field”) guarantees the Lumex DSC250 Lift Scale free from defects in materials and workmanship under normal use for two years from the date of purchase. If a product is deemed to be under warranty, GF Health Products, Inc. shall provide, at its option, (1) replacement of any defective part or product or (2) a credit of the original selling price made to GF Health Products, Inc.’s initial customer.
relied on any representation, assertion, guarantee, warranty, collateral contract or other assurance, except those set out in this document.
NOTES 15
GF Health Products, Inc. 2935 Northeast Parkway Atlanta, GA 30360 telephone: 770-368-4700 fax: 770-368-2386 www. grahamfield. com © 2013 GF Health Products, Inc.