Product Manual

6486A-INS-LAB-RevB14 1
6486A / 6487RA / 6487RA-1: RAISED TOILET SEAT WITH LOCKING
CLAMP; WITH SUPPORT ARMS: 6487RA / 6487RA-1
ASSEMBLY & OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
Info: The most current version of these instructions can be found online at www.grahamfield.com.
WARNING: Important! Read and understand these instructions before installing or using the
Raised Toilet Seat with Locking Clamp. If you do not understand any part of these warnings,
cautions or instructions, contact a healthcare professional for direction in the use of this
product. If the raised toilet seat is not properly assembled and installed, personal injury and
damage to the raised toilet seat could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT
use substitute parts. Use only Lumex replacement parts. Non-Lumex replacement parts could
cause personal injury and damage to the raised toilet seat.
WARNING: This product has a weight limit of 300 lb, EVENLY DISTRIBUTED.
WARNING: Notice for California Customers- California Proposition 65 WARNING: This product
contains a chemical known to the State of California to cause cancer and reproductive or
developmental harm.
WARNING: GF Health Products, Inc. assumes no responsibility for any damage or injury caused by
improper assembly, installation or use of this product.
INTENDED USE
The raised toilet seat is intended for use by those who have difculty sitting down on or standing up from the toilet.
6487RA6486A
flange paddle knob
INSTALLATION
1. Remove toilet seat from carton and protective packaging.
2. If installing Model 6486A, proceed to step 3.
If installing Model 6487RA, follow steps a-e to install arms, then proceed to step 3.
a. Remove arms from box.
b. Insert each end of arm into the raised toilet seat as shown in center picture above.
c. Push arm downward until you hear it click into place.
d. Pull arm upward slightly to secure proper installation. If loose, repeat step c.
e. Repeat steps b-d for other arm.
3. Lift lid and seat of toilet. This raised toilet seat ts most current, standard toilets.
4. Place raised toilet seat on toilet bowl rim, hooking rear anges under rear edge of bowl. Ensure paddle is back far
enough to clear inner rim of bowl. If not, turn knob counterclockwise.
5. Ensure raised toilet seat rests at on toilet bowl rim; straighten unit on bowl rim.
6. To tighten, rotate adjustment knob clockwise. Push unit back against rear of toilet rim while tightening knob. When
you feel resistance, turn an additional
1
/8 turn to snug. If top rear of unit hits the toilet seat or lid, you must remove
the seat and lid for proper installation.
Info: The adjustment knob head must be flush with the front of the toilet seat for proper fit. On smaller bowls, if
paddle is moved to rear of its travel, the knob may pop out of its original position; the knob will automatically re-
engage when you re-tighten. DO NOT force the knob to turn. If necessary, jiggle the knob a little to start the threads.
7. The raised toilet seat should now be securely installed on the toilet bowl. To ensure that you have a proper t,
intentionally shake the raised toilet seat to ensure proper placement and t. The raised toilet seat should not
move; if it does, re-install.
WARNING: Ensure the raised toilet seat is installed as described. If the raised toilet seat is not
properly assembled and installed, personal injury and damage to the raised toilet seat could result.