Product Manual

69623A-INS-LAB-RevB14 1
69623A / 69663A: TUB-GUARD
®
BATHTUB SAFETY RAIL
ASSEMBLY & OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
Tools required: an adjustable wrench
Info: The most current version of these instructions can be found online at www.grahamfield.com.
 WARNING:Important!Readandunderstandtheseinstructionsbeforeassemblingor
usingthe69623A/69663ATub-GuardBathtubSafetyRail.Ifyoudonotunderstandany
partofthesewarnings,cautionsorinstructions,contactahealthcareprofessionalfor
directionintheuseofthisproduct.IftheBathtubSafetyRailisnotproperlyassembled
andadjusted,personalinjuryanddamagetotheBathtubSafetyRailcouldresult.
 WARNING:Ifcomponentsaredamagedormissing,contactyourdealerimmediately.DO
NOTusesubstituteparts.UseonlyLumexreplacementparts.Non-Lumexreplacement
partscouldcausepersonalinjuryanddamagetotheTub-GuardBathtubSafetyRail.
 WARNING:Thisproducthasaweightlimitof250lb,EVENLYDISTRIBUTED.
 WARNING:NoticeforCaliforniaCustomers-CaliforniaProposition65WARNING:This
productcontainsachemicalknowntotheStateofCaliforniatocausecancerand
reproductiveordevelopmentalharm.
 WARNING:ThisproductisNOTrecommendedforuseonberglassorplasticbathtubs.
GFHealthProducts,Inc.assumesnoresponsibilityforanydamageorinjurycausedby
improperassemblyoruseofthisproduct.
INSTALLATION
 WARNING:DONOTovertightenBathtubSafetyRailadjustmenthandle.
1. Locate section of bathtub wall where Bathtub Safety
Rail is to be mounted. The Bathtub Safety Rail should
be mounted ONLY on the straight — not curved —
part of bathtub wall. Ensure the tub surface where
the Bathtub Safety Rail will be installed is smooth,
clean, and dry before installing the Bathtub Safety
Rail. Remove any dust, powder, or foreign particles.
2. Fold out the adjustment handle from the recess in
Bathtub Safety Rail body.
3. Loosen the adjustment handle by turning it counter-
clockwise until clamping mechanism is wide enough
to t over bathtub wall. Place Bathtub Safety Rail
down onto bathtub wall. Adjustment handle should
be outside the bathtub, and clamping mechanism
inside the bathtub. Ensure the Bathtub Safety Rail is
fully seated before tightening.
4. Tighten the adjustment handle by turning it clockwise until the Bathtub Safety Rail is rmly in
place on bathtub wall. DO NOT overtighten the adjustment handle.
5. Once unit is rmly in place, fold down the adjustment handle until the handle locks back into
the recess in the Bathtub Safety Rail body.
6. To test mounting before use, apply a strong push and pull motion to the Bathtub Safety Rail. If
the Bathtub Safety Rail moves, reset it and tighten it more.
 WARNING: EnsuretheTub-GuardBathtubSafetyRailisinstalledasdescribedbeforeuse.
Tub-Guard Bathtub Safety Rails
A) adjustment handle
B) clamping mechanism (one side only shown)
C) safety rail body
69623A
69663A
B
A
C
B
A
C