Operation Manual

LUMIGON T2 HD – USER MANUAL
Copyright © 2014 Lumigon A/S - All rights reserved
132

1 On a Home screen, touch the Menu key (=).
2 Touch “System settings”.
3 Under “Device”, touch “Behavior Control”.
4 Slide the switch in the top right corner to the ON position:
5 Touch the name of the prole you want to congure.
6 Touch the different elds, e.g. “From time”, “End time”, “Notication sound”,
“Notication light”, etc. to congure them.
7 When you are done, touch the “Save” icon in the top right corner (see the image).
NB. If you leave the screen without touching the “Save” icon, your changes to the
prole will not be saved.
Your behavior prole is now created, and will be activated at the time you
specied as its starting time. When a Behavior Control prole is active on your
phone, you will see the Behavior Control icon in the Status bar.

If you “pair” a specic Behavior Control prole with a Lumigon dock, the prole will be activated whenever you place the phone in this dock
and disabled when you remove the phone from the dock.
What makes “pairing” a Behavior Control prole with a Lumigon dock possible are the three switches under the rubber cover on the bottom
side of the dock. Each of the three switches can be set in two different positions - the top switch can be set in position 1 or 4, the middle
switch in position 2 or 5, and the bottom switch in position 3 or 6 (see the image below). As a result, the switches can be set in 8 different
combinations that are recognized by the phone when you place it in a dock. Each combination can be “paired” with a behavior prole.
Touch the “Save”
icon to save your
changes
Touch the
different elds
to congure
them