Installation Instructions

ManualsBrandsLumino ManualsBlinds & Shades2" White Room Darkening Cordless Faux Wood Flat Slat Blind - 23"W x 64"L

99-9049-000

2” Cordless Flat Slat Faux Wood Blind

Instructions for Installation, Operation & Cleaning

Congratulations on your Lumino

2 inch cordless ﬂat

slat faux wood blind purchase! You can take pride

and comfort in knowing that your new blind will be

easy to install, will add to your home’s beauty, and

will perform to your expectations. Before beginning

installation, please take a moment to review the

following instructions and safety warnings.

Time Required: 15 minutes

IMPORTANT SAFETY INFORMATION

Read all instructions, warning tags, and labels provided with your

product to avoid injury. Keep this manual. Please contact our

Customer Service Center at the phone number, email or address

inside this manual for additional support. For additional safety tips

visit the Home Safety Council at www.homesafety.org.

Tools Needed

3/32” drill bit (drill into wood)

7/32” drill bit (drill into drywall

for anchor)

Items in the Box

2” Flat Slat Blind 1

3 4

Hidden Brackets

Bracket Screws

Drywall Anchors

Wand

Headrail Endcaps

Hold Down Brackets

Hold Down Bracket Screws

Up to 48”

Wide

Over 48”

Wide

Summary of content (4 pages)

PAGE 1
2” Cordless Flat Slat Faux Wood Blind Instructions for Installation, Operation & Cleaning Congratulations on your Lumino 2 inch cordless flat slat faux wood blind purchase! You can take pride and comfort in knowing that your new blind will be easy to install, will add to your home’s beauty, and will perform to your expectations. Before beginning installation, please take a moment to review the following instructions and safety warnings.
PAGE 2
7 One Year Warranty Installation Instructions This warranty is provided to you by Lumino Inc. This warranty applies only to Lumino products that meet the following conditions: (1) You are the original retail purchaser of the product; (2) The product was properly installed in a residential dwelling, and; (3) The product was made or assembled exclusively from Lumino materials and components.
PAGE 3
6 Operating Instructions 3 4. Tilt headrail forward and mark location of internal components. For proper operation of the blind, brackets must be outside of this area. TO BRING BLIND DOWN TO WINDOW SILL: Pull blind down to the window sill by pulling down on the bottom rail. Note: You may pull blind all the way down to the window sill or stop at any desired height. Inside/Ceiling Mount Outside Mount 5. Mark screw locations.
PAGE 4
5 How to Correct an Uneven Bottomrail 8. Attach front lip of headrail into the front hook of each mounting bracket. 1. Fully extend the blind. 2. Pull down hard on the highest side of the bottomrail. 3. Push the bottomrail up to the headrail. 4. Fully extend the blind again. 5. Repeat steps until the bottomrail is level. • TIP: Be sure headrail is hooked onto all brackets before proceeding to step 8. Do not install blind one bracket at a time. 9.