Installation Instructions

99-9049-000
99-9049-000
6 3
4. Tilt headrail forward and mark location of
internal components. For proper operation
of the blind, brackets must be outside of this
area.
5. Mark screw locations. Align edge of bracket
either inside or outside of marks made in step
3, ensuring to avoid the “X.”
6. Drill holes:
• For drilling into wood:
Use a 3/32” drill bit.
• For drilling into drywall:
Use a 7/32” drill bit. Insert wall anchors.
7. Screw brackets into place.
Inside/Ceiling Mount Outside Mount
Inside/Ceiling Mount Outside Mount
Operating Instructions
TO BRING BLIND DOWN TO WINDOW SILL:
Pull blind down to the window sill by pulling
down on the bottom rail. Note: You may pull
blind all the way down to the window sill or
stop at any desired height.
TO FULLY OPEN BLIND:
Push blind up by pushing up on the bottom
rail. Note: You may fully open blind to top of
window or stop at any desired height.
TO TILT SLATS:
Twist wand left and right to open and close
slats to your preference.
TO CLEAN BLIND:
Dust gently with clean, damp non-abrasive
cloth.
Inside/Ceiling Mount Outside Mount
Inside/Ceiling Mount Outside Mount