Blood Pressure Monitor Instruction Manual Model Number 1092 ID #06/00 Requires 2 “AAA” Alkaline Batteries 2 YEAR LIMITED W ARRANTY
TABLE OF CONTENTS Identification of Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Battery Installation/Replacement . . . . . . . . . . . . . . . . . . . . . . . . 4 Attaching the Wrist Cuff and Posture During . . . . . . . . . . . . . . . 4 Measurement Measurement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Subsequent Measurement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Automatic Power-off Function . . . . . . . . . . . . . . .
Identification of Parts ts 3
Battery Installation/Replacement • To use the unit, you must install batteries. • Open battery cover as illustrated. Install or replace two new batteries, making sure the polarities (+ and -) on the battery match the polarities on the case. • Replace battery cover. • If the Low Battery indicator “ “ appears on the display, both batteries must be replaced. • “AAA” alkaline batteries or equivalent are suitable for this blood pressure meter.
Measurement NOTE: Unit measures on inflation. • To start the measurement Press the “Power/Start” switch. • The heart symbol will flash and the buzzer will sound for 1 second. When the unit completes the preparations for measurement, the buzzer will sound three more times. If batteries are weak, “❤ ” mark will not appear. • Pressurization and measuring begin. • When a pulse is detected, the pressure value moves to the lower side of the display. At this time the “❤” mark flashes and buzzer beeps.
played one above the other. • Unless an error is generated, the measurement results are automatically stored in memory (Up to 7 sets of results can be stored ). When there are already 7 sets of results in memory, the oldest one is automatically erased and overwritten with the newest. • Blood pressure values and pulse rate are alternately displayed. The unit will continue to display the measurement until power is turned off. • Turn Power off Press the “Power/Start” switch to turn off.
Memory Recall • You can recall stored data by pressing the “Memory Recall” switch at any time, EXCEPT while taking a measurement. • Up to 7 sets of measurement results can be stored in memory. Memory cell No. 1 is always used to store the newest set of results. • When pressing the “Memory Recall” switch, the memory cell number is displayed. The stored measurement results (systolic/diastolic blood pressure) are then displayed.
Description of Display Marks DISPLAY MARK CONDITION/CAUSE CORRECTIVE ACTION The cuff was inflated to more than 280 mmHg. Exhaust the air from the cuff. Pressurization is not possible. The wrist cuff was not wrapped properly. After rewrapping the cuff, repeat measurement. Pulse could not be measured accurately. After rewrapping the cuff, conduct the measurement without moving. The arm moved during measurement. Repeat the measurement without moving the arm. There is a problem with the unit.
Specifications Model No. 1092 Measuring Principle Measurement Localization Cuff Wrist Circumference Range Measurement Range Accuracy LCD Indication Oscillometric Method Left Wrist Soft Cuff 5.4 to 7.8 in. 0 to 280 mmHg 40 to 180 Pulses/min.
