User's Manual

the product. To do so, insert the card into its slot, turn the night vision
on and through the menu find and select “Format”, then select “OK”.
Once the card is formatted inside the night vision device it is now
ready to use.
TROUBLESHOOTING:
1. Unit does not turn on and the light indicator is off:
a) please check if the batteries are inserted correctly
b) please make sure the batteries are fresh
2. The light indicator is working, but you cannot see the image:
a) you may be turning the unit on in a dark area with the lens
cover still on the unit
b) You may need to turn on the infrared light
3. Unable to obtain sharp and clear image:
a) you may need to repeat the process of rotating the ocular and
objective lens several times until you get a good feel of it
b) You may be viewing an object that it too close – the minimum
focusing distance is approximately 80cm or 2.6ft
4. I switch from active image to photo/video review and the unit shuts off:
a) You are holding the Power button too long. You must only press
the Power button momentarily to activate this function.
5. Image freezes during operation or during initial turn on:
a) Open at least one battery compartment and then re-activate
the unit.
6. I’m trying to turn the IR illuminator on and instead I see the menu:
a) You are holding the IR button for more than 1 sec. In order to
turn the IR illuminator on, you must press the IR button only
momentarily.
WARNING! NEVER ATTEMPT THE FOLLOWING:
 Try to disassemble the unit by yourself or by anyone who is
not our authorized technician. Doing so may result in injury
and will void any warranty claims
 Charge batteries included with the unit – they are not
rechargeable!
 Charge ANY batteries inside the unit – it can only be done in
the correct battery charger!