Data Sheet

CDS Photoconductive Photocells
PDV-P5003
WWW.LUNAINC.COM
Precision – Control – Results
Information in this technical datasheet is believed to
be correct and reliable. However, no responsibility is
assumed for possible inaccuracies or omission.
Specifications are subject to change without notice.
Page 1/2
REV 10-24-16
© 2016 Luna Optoelectronics. All rights reserved.
Luna Optoelectronics, 1240 Avenida Acaso, Camarillo CA 93012 • Phone [phone] • Fax [phone]
DESCRIPTION
FEATURES
The PDV-P5003 are (CdS), Photoconductive photocells designed to
sense light from 400 to 700 nm. These light dependent resistors are
available in a wide range of resistance values. They’re packaged in a two
leaded plastic-coated ceramic header.
 Visible light response
 Sintered construction
 Low cost
RELIABILITY
APPLICATIONS
This LUNA high-reliability device is in principle able to meet military test
requirements (Mil-STD-750, Mil-STD-883) after proper screening and
group test.
Contact Luna for recommendations on specific test conditions and
procedures.
 Camera exposure
 Shutter controls
 Night light controls
ABSOLUTE MAXIMUM RATINGS
SYMBOL
MIN
MAX
UNITS
Applied Voltage
-
-
350
V
(TA)= 23°C non condensing 0.2 inch
from base for 3 sec with heat sink
Operating Temperature
-30
to
+75
°C
Storage Temperature
-30
to
+75
°C
Soldering Temperature
-
-
+260
°C
Wavelength Range
400
to
700
nm
Continuous power Dissipation
-
-
400
mW/°C
.366 [9.30]
.433 [11.00]
±.010 [0.25]
±.010 [0.25]
.079 [2.00]
-.010 [0.25]
+.015 [0.38]
COATED
PLASTIC
EPOXY ON LEADS 3mm MAX
1
.300 [7.62]
2
2X Ø.023 [.58] MAX
2X 1.00 [25.4] MIN
CERAMIC PACKAGE