Users Manual Part 1

Applying Graphic Label
Choose Graphic Label you would prefer.
Make sure the center and two holes where gold water
sensor pins will protrude are punched out.
Remove protective backer from label. Apply label to unit
making sure the gold pins push through the label
completely. Use your ngernail or dull blunt object to
secure around pins and on balance of label.
Test that sensor pins are not obstructed by wetting nger
and making contact across pins.
WARNING: LABEL CAN NOT BE REMOVED ONCE PLACED.
DOING SO WILL DAMAGE SEAL AND DEVICE WILL NO
LONGER BE WATERPROOF.
Holes Clear
Remove Backer