Installation Manual

Page 3 of 4
6
8
10
9
11
7
Installation Steps
NOTE: Actual application may vary slightly from illustrations.
Repeat Steps 3 thru 7 for passenger side bracket locations.
(Passenger side rear bracket shown)
Check boards for final position. Tighten all bracket to vehicle
body hardware to 40 lb-ft. Tighten running board to bracket
hardware to 17 lb-ft. Repeat Steps 1-9 for driver side.
Attach support bracket to pinch weld using (2) M6
Bolts, (4) M6 Washers, and (2) M6 Lock Nuts.
Align the passenger side nerf bar with the passenger
side front mounting bracket and loosely attach using
Bolt Assembly.
Bolt Assembly
Nerf bar
Repeat Step 9 to attach the nerf bar at the middle and
rear bracket locations.
Attach support bracket using M8 Bolt, (2) M8 Flat
Washers, and M8 Lock Nut.