Kickasspanel FULL COLOR User Manual
PLEASE NOTE: This manual is valid from 3.6 firmware version. SAFETY PRECAUTIONS: Do not operate the equipment before studying the instruction manual and the accompanying safety precautions. Make sure that Lupo Safety Instruction is always included with the equipment! Lupo products are intended for professional use.
Instructions • • • • • Device for indoor use only. Maximum ambient temperature: 35 °C. Make sure power supply plug is suitable for power required. To switch on the light push the on/off button. Kickasspanel model are equipped with new generation high quality powerleds. ATTENTION: when the C type cable is connected, and the unity is powered by Type C cable, the power is 50%.
Switching on the Kickasspanel 1 For battery use: insert the battery (not included) and switch ON the unit. 2 For use with USB cable: insert che USB cable in the USB port and switch ON the unit. * Charger SV min. 2A 3 For use with AC Adapter Connection: insert the Adapter Connection in the AC port and switch ON the unit.
CONTROL PANEL - In current mode press the « OK » - In the sub-menus press the « OK » » - Use the « or « 1 » - Use the « INTENSITY » - Use the knobs - Display 7 and 5 3 4 6 button to enter the main MENU. 2 2 button to confirm a selection. buttons to navigate in the main MENU and sub-menus. knob to adjust the light intensity from 0 to 100%. to adjust the light mode parameters. . MANUAL OPERATION 1. Press the « OK » 2 button to enter the main MENU. 2.
2. Save the set values in one of the available presets between USER PRESET 1 / 2 / 3 / 4 / 5 press the « » 1 or « » 3 button to select the PRESET number and press « OK » 2 to confirm the selection. THE SET COLOR IS SAVED AS PRESET. "BUSY" indicates that in the user preset there are parameters memorized if you select it, the parameters will be replaced by the new ones. "EMPTY" indicates that the user preset is free. E. SPECIAL EFFECT MODE: Mode with 10 SPECIAL EFFECTS.
Display: Time during which the display backlight stays on. 30sec / 1min / ALWAYS ON. Filter: It is the speed response of the system (smooth factor). FULL SPEED / NORMAL SPEED / HIGH SPEED / LOW SPEED. Linearization: Linearization is the compensation curve for the human eye’s perception of the luminous intensity emitted as a function of the required power. Required power = dimmer value on the display. LINEAR / EXPONENTIAL / LOGARITHMIC.
MENU e submenus MANUAL CCT MODE HSI MODE RGBW MODE PRESET MODE RED GREEN BLUE SOFT PINK ...