Installation Guide

INSTALLATION

Prt 2: Wire the Fixture

1. Run power to junction box

a. A. Remove the junction box’s outer cover by pressing down on the outer latch and pulling the

cover toward you.

Note: A licensed electrician should perform all the wiring tasks. All electrical connections must be

made within the junction box.

b. Run the conduit in (and out, if this is one downlight in a sequence).

Note: Maximum of ( 8 ) 12 AWG through branch circuit conductors suitable for 75˚ C permitted in

the box.

c. Run the building’s power line wires* into the junction box.

2. Splice wires

a. Using the provided wire nuts, splice the D3’s ﬂying leads into the building’s power. Make sure the

housing is grounded in accordance with local codes.

b. Replace the junction box’s outer cover.

3. Test wiring

a. Apply power to the D3. The emitter should immediately come on to 3000 K (warm white).

Note: If the emitter comes on red, see Diagnostic Colors, page 18.

b. Wait several minutes while the D3 tests its installation conditions. Then use the color to

c. determine whether installation was successful:

• If the light stays at 3000 K, installation was successful. Continue to step 8.

• If the light changes color, a problem has been detected.

Note: Magenta can indicate success or failure. It indicates success if there are no other powered-

on Ketra devices within 50 ft (15.24 m); otherwise, it indicates a problem.

To troubleshoot problems, see Diagnostic Colors, page 18.

d. After verifying a successful installation, remove power and continue to Part Three.

* Ketra lighting products should not be connected to, or directly controlled by, AC mains line voltage dimmers. These types of dimmers may also

be referred to as phase cut, triac, forward-phase, reverse-phase, ELV, or MLV dimmers. Ketra's lighting products should only be controlled via our

digital control architecture. Ketra does not recommend switching power on/o to Ketra lighting products via relays, contactors, or manual toggle

switches. When the lighting products are disconnected from power they cannot respond to digital commands from control devices. This could

confuse end users as the lighting may be in a state that is inconsistent with the control devices. Please refer to our controls products installation

guides for more information.

12|D3 INSTALLATION GUIDE

P/N 040444 Rev D