Installation Guide

INSTALLATION

Prt 3: Instlling Sheetrock

1. Ensure that the aperture is plugged with the cardboard insert to protect the optic.

2. Cut properly-sized hole in sheetrock before installing sheetrock. Reference table for sizes.

Type Hole shape and size

Mud-In Circle with 5.5” (139.7 mm) diameter

Flanged with square aperture Square with 4” (101.6 mm) length/width

Flanged with round aperture Circle with 4” (101.6 mm) diameter

3. Align the hole with the D3's aperture and install the sheetrock

Part 4: Apply Spckle Flnge Trim Retiner (Mud-In Only)

Note: Skip this section if you have a ﬂanged downlight.

1. Align the retainer assembly such that the holes in the retainer line up with the screw posts in the collar.

(see ﬁg. 9)

2. Secure the retainer assembly using the #632 fasteners. For ceiling thickness in range ⁄” (16.129 mm)

to 1-⁄” (28.575 mm), use the blue coded short set; for ceiling thickness in range ⁄” (225.425 mm) to

1-⁄” (38.1 mm), use the red coded long set.

Note: The retainer assembly should be ﬂush with the drywall.

ﬁg. 9

D3 INSTALLATION GUIDE|13

P/N 040444 Rev D