Installation Guide
INSTALLATION
Prt 5: Apply Joint Compound
1. Do a skim coat up to the aperture rim using a joint compound. (For mud-in versions, cover the flange
but not the retainer.) For best results, use a full ceiling float. (see fig. 10)
2. Sand and finish the final surface before removing the aperture plug. Clean the internal surfaces of the
trim retainer with a clean rag and isopropyl alcohol.
Prt 6: Apply Trim
Mud-in and flanged downlights have dierent processes for applying their trims. Please read only the
appropriate section below.
1. Applying trim to mud-in downlight
a. Press the flangeless trim into the trim retainer. (see fig. 11)
fig. 10
fig. 11
continued on next page
14|D3 INSTALLATION GUIDE
P/N 040444 Rev D
© 2019 Ketra, Inc. All rights reserved