Installation Guide
Additionl Opertions
1. Re-Aiming the Optic
a. Remove the trim by pulling the trim directly down from the housing.
b. Unlock the emitter chassis: reach into the D3’s housing and unlock tilt lock and rotation lock levers
(both colored red). (see fig. 14)
c. Use the degree indicators to determine degree of rotation (square trim only) and tilt.
(see fig. 15)
Rotation Lock and Release
Locked Unlocked
Tilt Lock and Release
Locked Unlocked
Tilt and Rotation Angle Indication
Tilt Rotation (Square Trim Only)
Tilt and Rotation Angle Indication
Tilt Rotation (Square Trim Only)
fig. 13
fig. 14
fig. 15
2. Adjusting Optic depth
a. Remove the trim by pulling the trim directly down from the housing.
b. To set optic at the deep regress position push optic directly up. Light engine will magnetically
lock into place (see fig. 16)
c. To set optic at the low regress position pull optic directly down. Light engine will magnetically
lock into place. (see fig. 17)
Emitter Regress Depth Adjust
To Raise: Push To Lower: Pull
fig. 16 fig. 17
16|D3 INSTALLATION GUIDE
P/N 040444 Rev D
© 2019 Ketra, Inc. All rights reserved