Installation Guide

ADDITIONAL OPERATIONS
fig. 18
3. Replacing the Optic
a. Remove the trim by pulling the trim directly down from the housing.
b. Ensure that the emitter chassis is locked.
c. Grab optic and twist counterclockwise to unlock. Pull toward you to remove.
d. Install replacement optic, twisting clockwise to lock. (see fig. 18)
4. Replacing the POWER SUPPLY
a. Remove the trim by pulling the trim directly down from the housing.
b. Tilt the Light Engine to 40°'s tilt and rotate to allow access to the power supply.
c. Unhook the emitter cable from the RJ45 jack on the power supply.
d. Pull power supply straight out from the docking station while depressing docking station latch.
e. Disconnect power supply quick connect (see fig. 19).
Primary Optic Replacement
Align to Shoulder Pins and Insert Twist to Lock
Primary Optic Replacement
Align to Shoulder Pins and Insert Twist to Lock
Primary Optic Removal
Twist to Unlock (Rotation lock should be set) Pull to Remove (Optic is not tethered!)
Primary Optic Removal
Twist to Unlock (Rotation lock should be set) Pull to Remove (Optic is not tethered!)
Tilt locked at 40˚. Emitter
Module in Full Regress
Disconnect power at the
Luminaire Disconnect
Unlocked and rotated so
that Emitter Module tilts
away from Power Supply
Disconnect
Emitter Module
D3 INSTALLATION GUIDE|17
P/N 040444 Rev D
© 2019 Ketra, Inc. All rights reserved