Quick Start Guide

Outdoor Plug
Welcome—and thank you for purchasing a
Caséta Wireless outdoor plug.
We hope you enjoy the convenience of
Caséta Wireless!
Power: 120 V~ 50 / 60 Hz
Load: Up to 15 A lighting / lighting transformers or
½ HP motor
Minimum RF Range: 60 ft (18 m) line-of-sight or
30 ft (9 m) through walls
Contents supplied
Double your warranty
Outdoor Plug
(PD-15OUT-BL)
Installing your outdoor plug
1
Decide on a suitable location
Love Caséta Wireless outdoor plugs? Have
ideas for making them better? Tell us what you
think and we’ll extend your warranty by 1 year.
www.casetawireless.com/register
Lutron Electronics Co., Inc.
7200 Suter Road
Coopersburg, PA 18036-1299, U.S.A.
Warranty
For warranty information, please visit
www.casetawireless.com/warranty
Go to www.casetawireless.com/support for
additional troubleshooting suggestions.
Symptoms Probable cause and action
Load / light does
not turn on.
• Light bulb(s) is /are
burned out.
• Outlet is switched off.
Load / light does
not respond
to Pico remote
control.
• The outdoor plug failed to
pair with Pico remote control;
see Pairing the outdoor plug
and Pico remote control.
• The Pico remote control
is outside the 30 ft (9 m)
minimum operating range.
• The Pico remote control
battery is low.
• The Pico remote control
battery is installed incorrectly.
Load/light does
not respond
to the Caséta
system.
• The outdoor plug was not
properly added to the Caséta
system. See Using your
Caséta Wireless outdoor plug
(with a smartphone or tablet).
• The outdoor plug is outside
the 30 ft (9 m) minimum
operating range.
Troubleshooting
For more information, tips for using Caséta Wireless
products, the complete Caséta Wireless product line,
and more, please visit
www.casetawireless.com/features
2
Mount the outdoor plug (optional)
3
Add a wireless control
Device Ratings
Outdoor Plug
PD-15OUT-BL
15 A lighting / lighting transformers
½ HP motor load
Wireless
Using your controls
Outdoor Plug
quick-start guide
Codes
Install in accordance with all national and local
electrical codes.
This device complies with part 15 of the FCC Rules and Industry Canada
license-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) This device may not cause interference, and (2) this
device must accept any interference, including interference that may
cause undesired operation. Modifications not expressly approved by
Lutron Electronics Co., Inc. could void the user’s authority to operate this
equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC/IC Information
P/N 0301976a
Important note:
Do not exceed the rating of the outdoor plug:
15 A maximum lighting / lighting transformers
½ HP maximum motor load
The end of the cord must be at least 3 in (76.2 mm)
above the ground.
Connect the outdoor plug to either your Caséta
system or to a Pico remote control (if desired).
See the reverse side of this sheet for details on how
to do this.
Note: The unit must be unplugged from the outlet
when mounting.
Using the mounting holes provided at the ends
of the outdoor plug, and using 2 screws or other
fasteners appropriate for your structure, mount the
outdoor plug to the structure. Use one mounting
hole at the top and one mounting hole at the
bottom of the outdoor plug. Ensure the outdoor
plug mounting location is close enough to the outlet
so the plug reaches the outlet and the end of the
cord is at least 3 in (76.2 mm) above the ground.
3 in
(76.2 mm)
minimum
3 in
(76.2 mm)
minimum
On / Off
Pico remote control
(sold separately)
On
Off
4
Plug in the load
The outdoor plug can control a variety of loads: lights,
lighting transformers, and small pumps and motors.
Simply plug your load into the outdoor plug.
WARNING: SHOCK HAZARD. May result in
serious injury or death. This device must be
plugged into a GFCI protected circuit.
Mounting
holes
Mounting
holes
Top
Bottom