Installation Guide

7
Symptom Solution
CFL or LED
bulbs do not
dim, have poor
dimming range, or
flicker / flash.
• Verify that the bulbs are marked
as dimmable.
• Adjust the dimming range (see step 7).
• Ensure the bulbs are on the Compatible
Bulb List at www.lutron.com/dimcflled
Bulb or dimmer
buzzes when lights
are on.
• CFL and LED bulbs have electrical
components that can make noise for a
variety of reasons. Since the amount of
noise is highly dependent on bulb design,
the best solution is to try a different bulb.
Lights do not
turn off.
• Move the slider down until it clicks into the
off position.
Other issues. • Please visit www.lutron.com/support
5
1
Limited Warranty:
www.lutron.com/TechnicalDocumentLibrary/
369-119_Wallbox_Warranty.pdf
)Lutron, Lutron, Claro, Satin Colors, Skylark Contour,
and C
•
L are trademarks of Lutron Electronics Co., Inc.,
registered in the U.S. and other countries.
Lutron Electronics Co., Inc.
7200 Suter Road
Coopersburg, PA 18036
©2017 Lutron Electronics Co., Inc.
OFF
ON
WARNING: SHOCK HAZARD.
May result in serious injury or death.
Turn off power at circuit breaker or fuse before installing.
Turn power OFF at circuit breaker
4
6
8
2
Disconnect wires.
Skylark Contour Dimmer
(single pole only)
For the list of compatible bulbs, please visit
www.lutron.com/dimcflled
If using CFL or LED bulbs,
they must be Lutron
compatible for optimum
performance.
Please read before installing.
P/N 0301845
Rev A
CTCL-150
120 V~ 60 Hz
LED
DEL
LFCA
CFL
AFC
150 W
CFL / LED
600 W
Incand. /Hal.
INC / HAL
Help
www.lutron.com/support
Ground (bare or green)
Optional
Operation
Black
Black
Green
With the slider at the lowest
light level (but not off), turn
the adjustment lever counter-
clockwise until there is no flicker.
Turn bulbs off and on. If all
bulbs do not turn on or are not
stable, turn the adjustment lever
clockwise slightly until there is
no flicker.
If bulbs are still flickering,
buzzing or dropping out, they
may not be compatible. Please
visit www.lutron.com/dimcflled
to check the Compatible Bulb List.
Slider
Select light level and
turn off lights.
3
Remove middle sections if mounting 2 or more devices side by
side. See table below for the new wattage limits.
NOTE: No derating is required when using only CFLs or LEDs.
NOTE: Black wires are interchangeable.
Remove
Keep
Maximum Ratings for Mixed Bulb Types
INC / HAL
Incandescent / Halogen
0 W + 600 W 500 W 400 W
1 W – 25 W + 500 W 400 W 300 W
26 W – 50 W + 400 W 300 W 200 W
51 W – 75 W + 300 W 200 W 100 W
76 W – 100 W + 200 W 100 W 50 W
101 W – 125 W + 100 W 50 W 0 W
126 W – 150 W + 0 W 0 W 0 W
LED
DEL
LFCA
CFL
AFC
CFL
IMPORTANT
1. CAUTION: Use only with permanently installed fixtures with dimmable screw-
in compact fluorescent, dimmable screw-in LED, halogen, or incandescent
bulbs. To avoid overheating and possible damage to other equipment, do
not use to control receptacles, motor-driven appliances, or low-voltage
transformer-supplied appliances.
2. Install in accordance with all national and local electrical codes.
3. When no “grounding means” exists in wallbox, the 2011 National Electrical
Code (NEC) allows a control to be installed as a replacement if 1) a
nonmetallic, noncombustible faceplate is used with non-metallic attachment
screws or 2) the circuit is protected by a ground fault circuit interrupter (GFCI).
When installing a control according to these methods, cap or remove green
wire before screwing control into wallbox and use an appropriate faceplate
such as Claro or Satin Colors series wallplates by Lutron.
4. For indoor use only between 32 °F and 104 °F (0 °C and 40 °C).
5. Dimmers may feel warm to the touch during normal operation.
6. Clean dimmers with a soft damp cloth only. Do not use chemical cleaners.
C
•
L
Up
Increases light level
Down
Decreases light level and
turn off lights
5
Troubleshooting
Remove existing device
Remove middle sections
(if ganging devices)
Connect the new dimmer
Mount dimmer
(using provided screws)
Turn power ON at circuit breaker
Adjust dimming range for CFLs and LEDs
Install wallplate
(not included)
Decreases brightness
Adjustment Lever
Increases brightness
Use our mobile friendly self-paced
installation tool:
www.lutron.com/wiringwizard
Find more product information:
www.lutron.com/support
- Videos
- Frequently Asked Questions
- Online Chat (8 am – 5 pm EST)
Call us 24 / 7:
U.S.A. | Canada | Caribbean
1.844.LUTRON1 (588.7661)
Mexico
+1.888.235.2910
Others
+1.610.282.3800