Cut Sheet
Operating voltage
•
120 V or 277 V @ 60 Hz
Lamp types and wattages
•
T5 HO: 24 W, 39 W, 54 W
•
T4 4-pin triple-tube CFL: 26 W, 32 W
Control options
•
3-Wire control
Available case types
•
A-case
•
C-case
Experience the benefits of full-range, 100% to 1% fluorescent dimming. Designed to meet the most
demanding lighting requirements, Hi-lume ballasts enable you to provide the ideal visual environment
for any application. The Hi-lume family is extensive, featuring the world’s only 100% to 1% dimming
ballasts for T4 compact fluorescent lamps. Integrating Hi-lume 1% technology into your designs
affords you full control over the lighting in any space.
Key standards
•
California Energy Commission Listed
•
UL Listed (evaluated to the
requirements of UL 935)
•
CSA certified (evaluated to the
requirements of C22.2 No. 74)
•
MIL Std. 461E compliant (meets the
requirements of CE101, RE101 and RE102)
•
Meets FCC Part 18 Non-Consumer
requirements for EMI/RFI emissions
Shown above: Hi-lume ballast, A-case
Model numbers are organized by lamp type, refer to pg. 41 for additional information.
Highest performance dimming to 1%
3-Wire controlled
Mounting
•
Ballast mounts using two screws (or sheet metal
feature and one screw) within a fluorescent fixture
•
Ballast is grounded via a mounting screw to the fixture
•
Lutron® and NEMA® recommend sockets
complying with IEC 60400. Sockets must have
a UL mark as well. Use rapid start sockets, not
instant startsockets.
•
Terminals accept 16-18 AWG (0.75 to 1.5 mm
2
)
solid copper or tinned stranded wire
Wiring
•
Hi-lume ballasts require 3 wires plus Ground
(Dimmed Hot, Switched Hot and Neutral); one
16-18 AWG solid copper Class 1 wire per terminal
•
Maximum ballast-to-lamp-socket lead length is
7 ft (2 m) for T5 HO linear lamps, and 3ft (1m)
for T4 compactlamps
•
Ballast is grounded via case
•
For control wiring diagrams, see pg. 70, and for
lamp wiring diagrams, see pg. 78.
Features
•
Continuous, flicker-free dimming from
100% to 1%
•
Ballasts maintain consistent light output for different
lamp lengths, ensuring fixture-to-fixture uniformity
•
3-Wire line voltage control for consistent fixture-to-
fixture dimming
• Sensors cannot connect directly to Hi-lume ballasts
•
Line-voltage miswire protection
•
Slim-profile design
•
Lamps turn on at any dimmed level without going
to full brightness
•
100% performance-tested, including burn-in at
the factory
Specifications
•
Total Harmonic Distortion (THD): less than 10%
•
Power factor greater than 0.95
•
Ballast factor equal to 0.95 for T4 lamps
•
Ballast factor equal to 1.0 for T5 HO lamps
Environment
•
Sound rating: Class A
•
Minimum lamp starting temperature 10º C (50º F)
•
Maximum ballast case temperature 75º C (167º F)
For system compatibility information, see pg. 12.
Ballasts and drivers | Ballasts and drivers |
32 | Lutron Lutron | 33
Hi-lume® ballasts Hi-lume ballasts