How to Guide

ManualsBrandsLutron ManualsLight DimmersMaestro 450-Watt Single-Pole Ivory Dimmer

MAESTRO CONTROLS

Smart Dimmers Smart Remotes

Have Questions? Call the Lutron Hotline 800-523-9466

To order—Call Lutron Customer Service 610-282-3800

JOB NAME AREA CONTROLLED

LOCATION JOB NUMBER

TITLE PAGE NO.

STANDARDS

SPECIFICATION SUBMITTAL

PRODUCT FAMILY FEATURES

• High-tech “Smart Dimmer” with microprocessor

technology for a standard designer wallplate opening

• Features a clean, flush, stylish appearance

• Special Features! Two taps on the switch brings lights

on to full brightness; press and hold the switch to

slowly fade lights to off over 10 seconds

• LED’s indicate light level and glow softly as a locator

light in the dark

• Multi-location dimming from up to 10 locations

• Uses standard single-pole and 3-way wiring for easy

installation in any home

• Raise from off

SPECIFICATION FEATURES

• Power- failure memory

• Frequency compensation

• Includes Radio Frequency Interference suppression

• Front accessible service switch (FASS

TM)

to disconnect load power

• Electrostatic discharge tested

• Precise color matching across all controls

The High-Tech Multi-Location Dimmer

Smart

Dimmer

Switch

Rocker Switch

Jacks Ports

Custom Multigang Wallplates

15A

Receptacle

15A GFCI

Receptacle

Single

Telephone

Jack

Cable

Jack

2-gang to 6-gang wallplates

6-Port

Frame

® Controls

www.lutron.com/maestro

One tap on to selected light

level/off; two taps full bright;

press & hold for 10-second

fade off

Press rocker to adjust light level

Front accessible service switch

(FASS

TM)

LED’S indicate light level,

glow softly

CLARO ACCESSORIES

Note: For multi-location dimming only-use one Smart

Dimmer (left) with up to nine Smart Remotes

Receptacles

Summary of content (10 pages)

PAGE 1
SPECIFICATION SUBMITTAL ® Controls www.lutron.
PAGE 2
® Controls www.lutron.com/maestro Description Model # SMART DIMMERS Incandescent Preset Smart Dimmers Single Pole/Multi-Location 600W MA-600Single Pole/Multi-Location 1000W MA-1000Products above: For multi-location dimming, use one Maestro Smart Dimmer with up to nine Maestro Smart Remotes, MA-R-. Not for use with mechanical 3-way or 4-way switches. Minimum load on dimmer is 40W. Derating required if ganged, see page 5.
PAGE 3
® Controls www.lutron.com/maestro Description Rating Model # SWITCHES General Purpose Switching of all Lighting Sources and Motor Loads Single Pole, 120/277V 15A 3-way, 120/277V 15A 4-way,120/277V 15A Products above: No derating required if ganged. CA-1PSHCA-3PSHCA-4PSH- ACCESSORIES Receptacles Receptacle 15A,125V GFCI Receptacle 15A,125V Products above: No derating required if ganged.
PAGE 4
® Controls www.lutron.com/maestro Description Model # STANDARD WALLPLATES 1-Gang W: 2.94” (75mm) x H: 4.69” (119mm) x D: 0.30” (7.6mm) CW-1- 2-Gang W: 4.75” (121mm) x H: 4.69” (119mm) x D: 0.30” (7.6mm) CW-2- 3-Gang W: 6.56” (167mm) x H: 4.69” (119mm) x D: 0.30” (7.6mm) CW-3- 4-Gang W: 8.37” (213mm) x H: 4.69” (119mm) x D: 0.30” (7.6mm) CW-4- 5-Gang W: 10.18” (259mm) x H: 4.69” (119mm) x D: 0.30” (7.6mm) CW-5- 6-Gang W: 12.00” (305mm) x H: 4.69” (119mm) x D: 0.30” (7.
PAGE 5
® Controls www.lutron.com/maestro DERATING/MAXIMUM CAPACITY No side sections removed (Full Capacity) One side section removed (End Units) Two side sections removed (End Units) Incandescent Dimmers 1 600W 1000W 500W 800W 400W 650W Electronic Low Voltage 2 600W 500W 400W Magnetic Low Voltage 1 600VA (450W 2) 500VA (400W 3) 400VA (300W 2) 1000VA (800W 2) 800VA (650W 3) 650VA (500W 2) DIMENSIONS Including Claro® wallplates – Wallplates sold separately. Dimmer Front Profile 0.31" (7.8mm) 4.
PAGE 6
® Controls www.lutron.
PAGE 7
® Controls www.lutron.
PAGE 8
® Controls www.lutron.com/maestro MAESTRO CONTROLS AND ACCESSORIES PART 1 – GENERAL 1.01 SUMMARY A. Scope: Provide, install and test all switches, dimmers and related devices as specified herein for the areas indicated on the drawings, specifications, and load schedules. B. Related Sections: Section 16580 (Ballasts), Section 16570 (Dimming Systems). 1.02 REFERENCES A. UL 1472, CSA, NOM, ISO 9001 1.03 SYSTEM DESCRIPTION AND OPERATION A. Permanently installed, wallbox mounted switches and dimmers B.
PAGE 9
® Controls n. Remotes shall wire using conventional 3-way and 4-way wire runs. o. Multi-location dimmers without neutral shall be capable of operating in either 3-way switch location. p. Wall controls shall fit a decorator wallplate opening with a flush tapswitch. Dimmers and remotes shall have a small, raised rocker to the right of the tapswitch. Dimmers shall have seven discrete LEDs to the left of the tapswitch. Tapswitches shall remain flush in both the on and off state.
PAGE 10
® Controls www.lutron.com/maestro b. Receptacles shall be two pole, three wire ground and rated for 15A at 125VAC. All receptacles shall be NEMA configuration type 5-15R. c. Ground-fault interrupter receptacles shall be Lutron Claro style with two-pole, three-wire ground and rated 15A at 125VAC Configuration shall be of the duplex type with rectangular NEMA WD-6 design. Receptacles shall have a 5 milliampere ground-fault trip level with "test" and "reset" buttons. 3.