Cut Sheet

®
SPECIFICATION SUBMITTAL Page
Job Name:
Job Number:
Model Numbers:
Maestro® Maestro 0–10 V Dimmer Sensor Sensor
369833a 2 08.27.14
Specifications
Regulatory Approvals
• UL Listed to U.S. and Canadian safety requirements
• Title 20/24 certified lighting control device
– Complies with Title 20 and Title 24 Section 110.9
Power
• Operating voltage: 120–277 V~ 50/60 Hz
Loads
• 8 A 0–10 V- electronic fluorescent ballasts or LED
drivers
• Works with all ballasts and drivers that provide
a current source compliant to IEC 60629 Annex
E.2, and whose inrush current does not exceed
NEMA410 standards for electronic ballast/driver
loads of 8 A steady state current.
• 50 mA max sink current
• Controls up to 25 ballasts or drivers (IEC 60929
Annex E.2 requires the ballast / driver to limit the
current draw to 2.0 mA maximum)
Environment
• Ambient operating temperature: 32 °F to 104 °F
(0 °C to 40 °C), 0%-90% humidity, non-condensing;
indoor use only
Warranty
• 5 Year Limited Warranty
For additional Warranty information, please visit:
www.lutron.com/TechnicalDocumentLibrary/Sensor_
Warranty.pdf
Key Design Features
Dimmer
• On a single-tap, lights fade ON or OFF
• On a double-tap, lights go to full ON
• Light levels can be fine-tuned by pressing and
holding the dimming rocker until the desired light
level is reached
• High-end trim (adjust maximum light level that can
be achieved, for energy savings)
• Low-end trim (adjust minimum light level that can be
dimmed down, to prevent flickering lights)
Additional Information on Sensors
• For single-circuit PIR MaestroR occupancy sensor
switch models, please see LutronR P/N 369666
• For MaestroR occupancy sensor C•LR dimmer models,
please see LutronR P/N 369748
• For dual-circuit PIR Maestro occupancy sensor
switch, please see LutronR P/N 369758
• For dual technology occupancy sensor switch models,
please see Lutron P/N 369773
• For more information, please see
www.lutron.com/occvacsensors
• Lutron Technical Hotline: [phone].
Select Design Feature Details
• Selectable dimming curve—linear or square law.
Drivers exist with linear response and some exist
with square law response. By providing a selectable
dimming curve from the 0-10 V- dimmer sensor, the
user is able to choose his/her preferred response for
optimized dimming performance.
• Miswire and incompatible load alert.
The user will receive a visual alert when the product’s
0-10 V- control wires are incorrectly connected or
an incompatible load is detected. In these conditions,
the product will still function as a switch. Refer to
Application Note 048536 for more details.
• Fade-to-On and Fade-to-Off.